Cr12MoV钢电火花辅助铣削实验研究
作者:
作者单位:

1.湖南科技大学 机电工程学院,湘潭 411201;2.韩国岭南大学 机械工程学院,大邱 38541

作者简介:

通讯作者:

中图分类号:

V261.94

基金项目:

国家自然科学基金(51905169,51775184,51975208)


Experimental Study on EDM-assisted Milling of Cr12MoV Steel
Author:
Affiliation:

1.School of Mechanical Engineering, Hunan University of Science and Technology,Xiangtan 411201;2.School of Mechanical Engineering, Yeungnam University Dae-dong,South Korea 38541

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以典型难切削金属材料Cr12MoV模具钢为研究对象,使用ABAQUS对其在电火花放电条件下温度场进行数值模拟,在不同进给率下对其进行传统铣削和电火花辅助铣削对比试验。借助高速摄像机、扫描电镜和测力计等设备,对其切削力特征、表面形貌和刀具磨损进行了对比分析研究。结果表明,电火花辅助铣削的切削力比传统铣削降低28.57%~51.47%,表面粗糙度降低2/3。与传统铣削相比,电火花辅助铣削在降低切削力、提高表面质量和减少刀具磨损方面具有显著优势。

    Abstract:

    In this paper, the typical hard-to-cut Cr12MoV die steel is taken as the research object. ABAQUS is used to conduct numerical simulation of the temperature field under electric spark discharge. Experimental results of the traditional milling and electric spark assisted milling are compared under different feed rates. By means of a high-speed camera, scanning electron microscope and dynamometer, the characteristics of cutting force, surface morphology and tool wear are analyzed and studied. The results show that the cutting force of EDM-assisted milling is 28.57%-51.47% lower than that of traditional milling, and the surface roughness is reduced by 2/3. Compared with traditional milling, EDM-assisted milling has significant advantages in reducing cutting force,improving surface quality and reducing tool wear.

    参考文献
    相似文献
    引证文献
引用本文

李常平,黄磊,李树健,李鹏南,高泰祖. Cr12MoV钢电火花辅助铣削实验研究[J].宇航材料工艺,2022,52(6):44-51.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2021-03-10
  • 最后修改日期:2021-05-29
  • 录用日期:2021-06-02
  • 在线发布日期: 2022-12-23
  • 出版日期: 2022-12-30
第十一届航天复合材料成形与加工工艺技术中心交流会 征文通知

关闭